250 head so far
- Thread starter DYNOED250
- Start date
A
Anonymous
Guest
Thats looking ok there mate!
I'm just finishing up one for my 280 cube stroker motor ... flowed just over 400hp of air on my flowbench
I'm just finishing up one for my 280 cube stroker motor ... flowed just over 400hp of air on my flowbench
Sweet.... thats way lots of cubes.. . Before porting it flowed 130cfm@10 inches at 450 tho lift and didnt increase after the 450" lift mark. Hoping for at least 150-160 cfm@10inchs. Its all flow bench jargen, the real test is bolting it all back on and hopefully running some bigger MPH down the 1/4.. Its just takes time.. Gota make sure now that the inlet manifold is up to it
A
Anonymous
Guest
Sounds good. I can't remember what the head of mine flowed off the top of my head. I'll have a look tomorrow.
As for intake manifolds, heres a crappy pic of the home made jobby I use on mine
Note: this is a well old pic .... I still cringe at looking at the setup in this pic :roll:
As for intake manifolds, heres a crappy pic of the home made jobby I use on mine
Note: this is a well old pic .... I still cringe at looking at the setup in this pic :roll:
Similar threads
All Small Six
Any Large Log Head Blueprints Available?