gettin it back tomaro

[Junk-Falcon]

the shop just called , its done arty: , bored 30 over , crank cleanedup at 10 n 10 with a polish ,, deked 10k , cam bars instaled , silvelite pistons pressed on rods resized with arp bolts , n its balnced with the alum 8 1/2" fly wheel , molly rings , honed with 400 grit , get to pick it up in the mornin hope to put it togther this wk n start puttin it in the van by next wk end ,, yeeha the dogy van will live

 

[Anonymous]

Which cam are you going to use?
Ken

 

[Junk-Falcon]

264/264 112* 1400-5000 rpm from ford six

not much but it will be a lot of just crusing

 

[Anonymous]

Sounds like a fun set up. You did the head up too?
Ken

 

[Junk-Falcon]

no im just useing the head off a 68 motter , it was done with a 3side valve job no more than 7k ago , im going to put in 289 springs but thats about all , ill look n see if i think its worth a lap in , but im thinkin itll be ok for now .
im not shure what way i want to go on the head , 3 webers ,maybe alu head , but im not shure that will fit in the dog house

for now i ordered a new Vaporizer 1100 from pony n see if its worth running just 1