All Small Six PCV PROBLEM

This relates to all small sixes
D

Derek

New member
I have a 66 mustang 200ci I6 and recently modified with electronic ignition, a Weber 32/36 2v carb and adaptor plate from vintage inlines. The problem is I couldn’t use the carb spacer because the hood wouldn’t close. What do I do about the pcv and hose. I see no place to install whet it would pull vacuum. Not sure what to do?
Derek
 
Hook it up to the log under the carb mounting there is a boss with pipe threads there if you have a 1968 or older log head. You might have to get a T fitting if you already have something else installed there. If it's a later model log head then the boss is on the top of the log near the front of the engine. Good luck
 
I am talking about on the side of the Heads Log Intake Manifold it's an 1 inch or 1 1/2 inches below were a stock carb bolts on to the Log, not the carb spacer or adapter. Can't see it in your picture above because it located on the outher side of the engine.
 
You have to install a pcv fitting below the carburetor.
Do not mount it on the log, cause you will lean those cylinders.
 
You must log in or register to reply here.
Back
Top