Would this be good cam for mild turbo 200?

A

Anlushac11

1K+
VIP
Classic Inlines CSC-264-HSP-12

264/264, .450/.450, 114*, 1400-5000

Opting for 114 lobe centers over the 112 lobe centers.

For a 3100lb Fox body Mustang, C4 automatic, ported and polished head. Either port EFI or central mount TBI, about 8 to 10lbs boost, 3" exhaust, engine rev limited to 6000rpm.

Hoping to hit 200hp but anything would be better than the current estimated 45rwhp and 4500rpm max.

Setting car up to run E85 to take advantage of the alcohol and 106 octane.

Keeping low boost and high octane to keep stock cast pistons.

Will have TFI distributor and Megasquirt II ECU.
 
8) i think the 112 lobe centers would be better, but over all the cam is a good selection
 
That cam will work, make sure you tell Mike your going to run boost and ask him to send springs with 10-20 psi more pressure then N/A to overcome the boost pressure, if you keep the Compression ratio down it will run fine on pump gas at 10 psi, make sure the heads combustion chamber has no sharp edges or casting flash, and you should make your 200hp number plus
 
You must log in or register to reply here.
Back
Top