I am stripping down a DGV to rebuild it for my '61 Falcon. I am unable to remove the emulsion tubes. How do I remove them? Google was not my friend - or I did not use the correct search words.
I have thought of tapping the inside of the tubes and using a slide hammer but I suspect that the tubes would not function the same afterwards with the bore tapped. Another thought that I have had is to heat the carb body with a propane torch to try to expand the body and break the corrosion between the two parts but I am concerned about warping the casting. Other suggestions? BTDT?
I have thought of tapping the inside of the tubes and using a slide hammer but I suspect that the tubes would not function the same afterwards with the bore tapped. Another thought that I have had is to heat the carb body with a propane torch to try to expand the body and break the corrosion between the two parts but I am concerned about warping the casting. Other suggestions? BTDT?