Some questions on sensors and hole in block

Anlushac11

1K+
VIP
I am trying to figure out where the oil pressure sending unit and water temperature sending unit go.

I was thinking the water temp unit was on front of head by thermostat and where does the oil press sending unit go? I was thinking it was on back of head but I have a big threaded hole on drivers side of block behind dipstick tube.

Thanks, Any help appreciated

Mark.
 
Mark, the temp sensor is located on the left rear of the cylinder head.
The oil sender or guage in 4" down on the left side of the block below the center line of #6 cylinder.
The heater hose outlet is on the right front of the cylinder head. Bill
 
Back
Top