trans to block bolt size help

quick question, Ive had the tranny out of my car for far too long and apparently didnt just thread the bolts back into the block, so now of course I cant find where I put them. So if someone can tell met the length and thread I need, I'll go scronge the bolt bins at the hardware store and hope i can get close.

Thanks!

From correspondence with my buddyAnlushac11. Its normal to get the bolts mixed up, even when you've labelled eveything so I hope those posts help

Its common to use whatever the 3.3/200 came with, but there were some changes to metric headed SAE bolts. 2.36" is the best length so the bolts won't ground out but depending on the trans, you can ses the same bolts as the long bolts on the iron exhast header. SAE 7/16 - 14 X 2 1/2 inches long. If they bottom out, just hacksaw 140 thou off them, and chamfer ends with a rathole or Millsaw B@$+ard file

http://vb.foureyedpride.com/showthread. ... -200-I6-C4

other bolt sizes viewtopic.php?f=1&t=69316&p=531620#p531620

torques for some of the bolts viewtopic.php?f=1&t=68787&p=527285#p527285

you freaking rock!

US 200 is 3/8-16