Two of the gasket and head ,bolt holes are made smaller for this on pass side, front and back ,for best alignment. Look at it you will see them. Put them there.Dragonlich1961":1rkqkhr5 said:use some old head bolts as guides to make sure the gasket and head are aligned. (cut the head off and cut a slot in it for a screw driver).
Dragonlich1961":2ofybsox said:use some old head bolts as guides to make sure the gasket and head are aligned. (cut the head off and cut a slot in it for a screw driver).
X2RichCreations":31yi0ktz said:Dragonlich1961":31yi0ktz said:use some old head bolts as guides to make sure the gasket and head are aligned. (cut the head off and cut a slot in it for a screw driver).
Or switch to arp studs ;-)