Order of execution on a build

I have sleeved quite a few blocks over the years when working with hard to find and antique blocks. This would get you back to a standard bore again. The sleeves are not so expensive but I don't know what the labor is today to install them. I wonder what the cost would be to have a run of new 200 and 250 blocks made? Good luck (y) :nod:
 
just fyi: I C the heads done by the nationals, Bubs -
(C Jegs now. Summitt just stoped...)

Yes, a slieved block is fine
 
I try "ford inline" when nothing comes up. You might get that second one for cheap.
 
Still like'n da title of this thread...

For me?
car-part dot com
is all ways my 1st 'go to'

http://www.car-part.com/cgi-bin/search.cgi

I just selected a late model & Kansas as I don't know where U live.
If seeking a very slo'n low cost shipper PM...
EDIT:
I now C & remember U R in SoCal. Just plug dat in to the box for ur location.
Or do a lill wrk & locate 'nearest'...
 
Hi Chris, was just wondering how you doing on your Mustang 200 rebuild project? (y) :nod:
 
You must log in or register to reply here.
Back
Top