Dyno locations anyone?

Moderator: Mod Squad

69stang_250
Registered User
Posts: 467
Joined: Thu Aug 13, 2015 1:47 pm
Location: Covington, Louisiana
Contact:

Dyno locations anyone?

Post #1 by 69stang_250 » Sun Jul 15, 2018 2:46 am

Hey guys. I know there is a section for machinists and engine builders, but was wondering if we could start one for engine dyno and chassis dyno locations? I have been hunting around south east Louisiana and not having much luck. If anyone knows of a good chassis dyno along the gulf coast area please let me know!

Thanks in advance.
69 mustang coupe, 250 .030 over, forged pistons, port & polished CI AL head 54cc's 10.25CR, 280/280 Clay smith cam 1 degree advanced, 1.6 adjustable rockers,
Re curved DSII, MSD AL6, CI Intake, FITech 400HP fuel injection. T5 trans, 8" rearend w/3.80 gears, Eaton trutrack.

User avatar
62Ranchero200
Registered User
Posts: 431
Joined: Fri May 18, 2012 10:38 am
Location: Houston, TX
Contact:

Re: Dyno locations anyone?

Post #2 by 62Ranchero200 » Sun Jul 15, 2018 10:35 pm

Serious HP on the west side of Houston, on Brittmore Road near the west side of Beltway 8. $90 for three pulls.

Thanks,
Bob
62 Ranchero, 252 cid, 300 rods, RaceTek pstns, ARP mains bolts & studs, balanced & blueprinted, CI AL head, 1.6 adj rckrs, Smith Bros, 274/274/108 cam, CI int, Holley 500, DSII, CI SS hdrs, PowerMaster strtr and 1wire alt, Optima, V8 rad, T-5z, 10" organic clutch, 5 lug 8" w/3.80 Trac Loc, rear drums, front 5 lug discs, Centerlines. Next: ?.

Who is online

Users browsing this forum: No registered users and 26 guests