GreasyNRusty
New member
Kinda got the hots to build a 250...but the project I have in mind for it requires an inline four or a (yuck) 60-degree (puke) V-6 :tabu: .
The kit roadster was designed around a Ford 2300, which is approximately 23", front of single-groove crank pulley to bellhousing flange at back of block.
I'm wondering if someone could provide a similar length measurement, front of 3-groove crank pulley-to-bellhousing flange for a 250?
Thanks, Eddie
The kit roadster was designed around a Ford 2300, which is approximately 23", front of single-groove crank pulley to bellhousing flange at back of block.
I'm wondering if someone could provide a similar length measurement, front of 3-groove crank pulley-to-bellhousing flange for a 250?
Thanks, Eddie