Click Here -> Please Consider Making a PayPal Contribution to the FordSix Forum!
2019 Contributors:
NJwpod, 1strodeo, mightynorseman, maxtrux, 6d7coupe, broncr, Phase3, 68Flareside240, bmbm40,
mustang6, WorldChampGramp, justintendo, BigBlue94, ags290, motorsickle1130, Rooster, ousooner919, ethanperry
rzcrisis, DoctorC, jamyers, Motorboy, fastpat, Silverback280, chad

<<< New Site Update >>>

Thread pitch on Clifford 6=8?

Moderator: Mod Squad

Registered User
Posts: 47
Joined: Wed Jan 29, 2014 7:19 pm
Location: Wisconsin

Thread pitch on Clifford 6=8?

Post #1 by huntnfish08 » Fri Jul 12, 2019 3:35 pm

I've got a Clifford intake and would like to put in a vacuum barb. There is a hole centered below the carb mount that a 3/8-16 bolt will thread into but they don't seem to offer that thread to barb adapter.
Any help on this thread pitch?
Adam White

1978 F150, 300cid, NP435/205, 4x4
Clifford intake, 2150 1.08" 2bbl, comp 1.76:1 rockers, EFI exhaust manifolds.


User avatar
Global Moderator
Posts: 9127
Joined: Sun Jan 03, 2010 4:46 pm
Location: Flagstaff, Az. 86005 near the old Route 66

Re: Thread pitch on Clifford 6=8?

Post #2 by bubba22349 » Fri Jul 12, 2019 5:22 pm

Should be iron pipe threads, Try a 1/4 inch NPT. Good luck :nod: :thumbup:
A bad day Drag Racing is still better than a good day at work!

I am still hunting for a project car to build but with my current low budget it's not looking so good. My Ex- Fleet of Sixes these are all long gone! :bang: 1954 Customline 223 3 speed with O/D, 1963 Fairlane project drag car with BB6, 1977 Maverick 250 with C4, 1994 F-150 a 300 with 5 speed.

Who is online

Users browsing this forum: No registered users and 4 guests