Oil Port

A

AngryEyes

Active member
Hey Guys, Tommorow Im getting a BUNCH of lines made up for myself. Fuel, oil, and vac. AS well as picking up 30 feet of 4 gauge wire :D

BUT. ... I know my fuel sizes, I know my turbo sizes, I know my drain sizes. I DONT know the size of the port I need to T into on the block of my 250 my understanding is I need a T that taps into my block, and on one side is the oil sending unit and the other is my Oil feed

Like so : sending unit ---*--- block
Where * is a line that goes to the turbo

Does anyone know off hand the sizes I need? My car is 100 km away from me atm, so I cant check my self, and my Chiltons is... in the passenger seat.
 
I think that would be a 1/4 inch NP or 3/8 inch NP (US) pipe thread in the block you might also post your question in the (144, 170, 200, 250) small six forum and get a more exact answer. Good luck :nod:
 
You must log in or register to reply here.
Back
Top