Need intake info.

turtlejam

New member
Hi everyone i'm hoping someone can help me.A professional turbo engine builder http://kawellracing.com/ has recommended a Turbonetics T3 turbo with 50mm inducer,57mm exducer,dynamic seal.This spec was based on an intake with 2 1/4" log and 1 5/8" runners.

I need to find the i.d. of the log and runners for the factory 200 intake.This is needed so he can recommend another size turbo if the T3 isn't the best choice.I'm wanting to run stock manifold.Thanks.......Greg
 
Here is info on log volume and carb bore
ci/HeadSwap.html

I would think that you can measure the log ID by the size of the plug at each end.
2 1/4" ID is much larger than what the stock logs will be.
 
Article states it won't go into the intake volumes.Checking o.d. of plug in the manifold end is an excellent idea,thanks for the tip.I can't check my engine it's stored until the weather here is in the double digits thanks again.
 
Back
Top