crossflow / C4 bellhousing measurments

falconator

Active member
Could anyone tell me what the measurment is between the top mounting holes, center to center on a crossflow C4 bellhousing ( or on the block ) I am trying to find something that will work without getting one shipped from Aus. Any ideas ? Thanks, Mike
 
i thought there were a few guys that had some in the states. oh well. the thing is heavy as heck. i just realized i'll have to drive stick.
 
Falconator,
I have a 82 carbureted xflow sitting on an engine stand. I also have an auto gear box (Borg Warner) and a manual gear box (unknown) bell sitting behind the shed. Tell me what measurements do you need? I will measure and post them for you.
David in Dayton, TX
 
Back
Top