Click Here -> Please Consider Making a PayPal Contribution to the FordSix Forum!
2018 Contributors:
StarDiero75, curts56, DannyG, B RON CO, wsa111, Captainslow42, falconcritter
Econoline, THE FRENCHTOWN FLYER, 95FordFleetside, turbo6, Max_Effort, WorldChampGramp
cr_bobcat, C.S.Designs, pmuller9, gus91326, rwbrooks50, rocklord, drag-200stang, Big64my79Effie, CNC-Dude, gb500

2019 Contributors:
NJwpod, 1strodeo, mightynorseman, maxtrux, 6d7coupe, broncr, Phase3, 68Flareside240

Unknown->> S.Wickett, D.Blaine - Please PM me (1966Mustang) and lemme know who you are!

63 F100, Las Cruces, NM

Moderator: Mod Squad

Registered User
Posts: 7
Joined: Thu Jan 18, 2018 10:20 pm

63 F100, Las Cruces, NM

Post #1 by Marcorod » Sat Jan 20, 2018 11:32 am

What’s up guys, this is my first post and thanks for accepting me to this vast collection of knowledge. First of all I just rescued a 1963 f100 from back yard, guy promised me it would start right up so I got to work his son had tried to lower it by putting rear axel under leaf springs with body lift kit and drive shaft hit bottom of bed??? But I put everything as it was, did tune up, added tires and sure enough a little gas in carb fired right. I have many questions about truck but am not sure how to go about asking them or where? But I am new so lend a hand thanks

User avatar
Global Moderator
Posts: 8655
Joined: Sun Jan 03, 2010 4:46 pm
Location: Flagstaff, Az. 86005 near the old Route 66

Re: 63 F100, Las Cruces, NM

Post #2 by bubba22349 » Sat Jan 20, 2018 3:25 pm

Welcome to the Ford Six site Marcorod, and congrats on getting your 63 F100. Best of luck on the repairs :thumbup: :nod:
A bad day Drag Racing is still better than a good day at work!

I am still hunting for a project car to build but with my current low budget it's not looking so good. My Ex- Fleet of Sixes these are all long gone! :bang: 1954 Customline 223 3 speed with O/D, 1963 Fairlane project drag car with BB6, 1977 Maverick 250 with C4, 1994 F-150 a 300 with 5 speed.

Who is online

Users browsing this forum: No registered users and 1 guest