Adding a groove to a 68 crank pulley

Moderator: Mod Squad

68BlueStraight6
Registered User
Posts: 33
Joined: Tue Jul 05, 2016 3:05 pm
Location: Middletown, NJ

Adding a groove to a 68 crank pulley

Post #1 by 68BlueStraight6 » Sun Sep 04, 2016 6:34 pm

Is it possible to use this: http://www.cjponyparts.com/170-200-cran ... ey/p/CSP3/
On a 68 200. The dates similar parts refer to are for a 65-67. Will this also bolt up to my crank pulley to have a second groove to run a power steering pump?

Thanks,
Kris

User avatar
bubba22349
Global Moderator
Posts: 7383
Joined: Sun Jan 03, 2010 4:46 pm
Location: Flagstaff, Az. 86005 near the old Route 66

Re: Adding a groove to a 68 crank pulley

Post #2 by bubba22349 » Mon Sep 05, 2016 12:26 pm

Dose your 1968 have a three bolt balancer? If it dose it likely will fit. Good luck :nod:
A bad day Drag Racing is still better than a good day at work!

I am still hunting for a project car to build but with my current low budget it's not looking so good. My Ex- Fleet of Sixes these are all long gone! :bang: 1954 Customline 223 3 speed with O/D, 1963 Fairlane project drag car with BB6, 1977 Maverick 250 with C4, 1994 F-150 a 300 with 5 speed.

68BlueStraight6
Registered User
Posts: 33
Joined: Tue Jul 05, 2016 3:05 pm
Location: Middletown, NJ

Re: Adding a groove to a 68 crank pulley

Post #3 by 68BlueStraight6 » Mon Sep 05, 2016 3:40 pm

It does have the three bolt holes. Does this attach with the three bolts or the center crank bolt, or both? Do I need a longer crank bolt? Thanks for the response.

User avatar
bubba22349
Global Moderator
Posts: 7383
Joined: Sun Jan 03, 2010 4:46 pm
Location: Flagstaff, Az. 86005 near the old Route 66

Re: Adding a groove to a 68 crank pulley

Post #4 by bubba22349 » Tue Sep 06, 2016 1:45 am

It attaches with the three outer bolts plus the center crank bolt. The crank bolt is probally long enough but if you wanted to find another just add the pulley and measure the depth of the crankshaft hole plus the washer and compare that measurement depth as it is now without the add on pulley to the lenght of your existing bolt and washer. Good luck :nod:
A bad day Drag Racing is still better than a good day at work!

I am still hunting for a project car to build but with my current low budget it's not looking so good. My Ex- Fleet of Sixes these are all long gone! :bang: 1954 Customline 223 3 speed with O/D, 1963 Fairlane project drag car with BB6, 1977 Maverick 250 with C4, 1994 F-150 a 300 with 5 speed.

Who is online

Users browsing this forum: No registered users and 1 guest