Aluminum Head Update 4/24/06

AzCoupe

1K+
Departed Member
Well, the patterns are just about complete. Close enough to cast up a couple preliminary heads. One will be cut up and closely scrutinized. The other is being machined and sent to me for basic testing (bolt patterns, etc) and as a show piece for the upcoming shows. They plan to cast them someday this week, so I should have one in my hands in two or three weeks.

If the head looks good after cutting it up, they'll put the final touches on the patterns and move forward. This means we might see some prototypes for dyno testing sometime around the end of May. ;)
 
CobraSix,

Don't hate Mike just give me that old head with the embarrassing rattle and buy one of Mike's really nice aluminum heads.

I'll throw that old head on my junk heap and run it for awhile. I know you wouldn't want to see it crushed.

Just leave those exhaust studs in there I know they are a majot PITA but I will somehow overcome it.

Bob
 
Back
Top