I bought some dual springs from Mike. I am putting them in at 1.595 since that is where my retainer and 0.060 thick locators (on the aluminum head) put me. Around 1.600 should be fine. Always check for coil bind and retainer to guide/seal clearance.
Thanks Dan. I was figuring around 1.600".Its good to get confirmation. I may use longer valves for more installed height. I'm not worried about the stock valve train geometry since I'm not using stock rockers.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.