Any intake manifold for side draft webers for the Alum Head

Is there any Intake Manifold available for Side Draft Webers for the Aluminum Head ??

I was thinking of 3 Side Draft webers like this :


http://www.youtube.com/watch?v=0ZLMLVXj ... re=related

or

http://www.youtube.com/watch?v=1rkbHS05QSA

If Yes,

1) Who sells it ?
2) Would it be a good combination ?
3) Would it be bad on MPG ?

Looks like some people in argentina are doing it to their inline 6 Ford Falcon's. Thanks in advance .

Hear are some of the video's I found of the Argentinian Falcons with triple Webers :

http://www.youtube.com/watch?v=F623xrm0 ... re=related

http://www.youtube.com/watch?v=9zo5pPNf9DQ&NR=1

http://www.youtube.com/watch?v=V1jenPQp ... re=related

http://www.youtube.com/watch?v=cXuq85KN ... re=related

that is insane!

Have you looked at this post? You might contact by (PM) xctasy about your wants. He's developing some parts packages to use with the CI Alum head.

viewtopic.php?f=5&t=65023

Here is two complete Weber setups for the 250 2V head:

http://www.ebay.com.au/itm/Ford-250-2V- ... 4cf919aec0

Shows that manifolds are available, at least in Australia.

rocklord":2zoj30ak said:

Here is two complete Weber setups for the 250 2V head:

http://www.ebay.com.au/itm/Ford-250-2V- ... 4cf919aec0

Shows that manifolds are available, at least in Australia.

Click to expand...

I have been thinking of doing this also....
Bill

If enough interest and people want one, I can make some of them. Im doing patternwork for several Cheby intakes right now. A Weber style intake like that would be fairly easy to make and have cast. I already have the intake ports drawn and in a DWG file, so im halfway there already....

CNC Dude:

After casting up the 3xDCOE manifold(s), I wonder if you could develop an alternate plenum that would bolt up instead of the Webers, and then have several plenum top plates for various combinations of carbs or throttle bodies? Perhaps a way to leverage the triple Weber manifold effort ...

Russ

Russ, are you talking about this for the Oz head or the Cheby's. Thanks.

Scott:

If done right, the plenum tops could apply to any inline six you built 3xDOCE manifolds for. The plenum might have to be a bit different for each application due to the difference in intake port spacing but they should all be similar.

Russ