Release fork/bell housing boot

Moderator: Mod Squad

196158A
Registered User
Posts: 32
Joined: Sun Apr 22, 2018 2:23 pm

Release fork/bell housing boot

Post #1 by 196158A » Mon May 07, 2018 6:52 pm

for a '61 2.77 3spd. The original was a leather affair as I remember. Is there a replace/repro part to replace this rotted one?

Tnx
Terry

User avatar
bubba22349
Global Moderator
Posts: 8439
Joined: Sun Jan 03, 2010 4:46 pm
Location: Flagstaff, Az. 86005 near the old Route 66

Re: Release fork/bell housing boot

Post #2 by bubba22349 » Sun May 20, 2018 4:28 pm

Hi Terry, the clutch arm dust boot was made out of rubber. You can get a new one from Falcon Parts .com (see below link) good luck on your Falcon :thumbup: :nod:

https://www.falconparts.com/ford-falcon ... 48p611.htm
A bad day Drag Racing is still better than a good day at work!

I am still hunting for a project car to build but with my current low budget it's not looking so good. My Ex- Fleet of Sixes these are all long gone! :bang: 1954 Customline 223 3 speed with O/D, 1963 Fairlane project drag car with BB6, 1977 Maverick 250 with C4, 1994 F-150 a 300 with 5 speed.

Who is online

Users browsing this forum: No registered users and 10 guests