92 4.9 to E40d spacer plate

Moderator: Mod Squad

psa1sonic
Registered User
Posts: 47
Joined: Sat Jan 07, 2017 10:56 pm

92 4.9 to E40d spacer plate

Post #1 by psa1sonic » Sat May 12, 2018 4:55 pm

So a few months ago I took apart my motor and trans. I could swear I had a spacer plate. There is one for this motor combination correct? I think my mother inlaw cleaned up the garage to be nice and now I am trying to remember if I had one.

User avatar
bubba22349
Global Moderator
Posts: 7991
Joined: Sun Jan 03, 2010 4:46 pm
Location: Flagstaff, Az. 86005 near the old Route 66

Re: 92 4.9 to E40d spacer plate

Post #2 by bubba22349 » Sat May 12, 2018 8:47 pm

Yes it should of had a spacer plate. Good luck :thumbup: :nod:
A bad day Drag Racing is still better than a good day at work!

I am still hunting for a project car to build but with my current low budget it's not looking so good. My Ex- Fleet of Sixes these are all long gone! :bang: 1954 Customline 223 3 speed with O/D, 1963 Fairlane project drag car with BB6, 1977 Maverick 250 with C4, 1994 F-150 a 300 with 5 speed.

psa1sonic
Registered User
Posts: 47
Joined: Sat Jan 07, 2017 10:56 pm

Re: 92 4.9 to E40d spacer plate

Post #3 by psa1sonic » Sun May 13, 2018 8:47 am

bubba22349 wrote:Yes it should of had a spacer plate. Good luck :thumbup: :nod:

I found it. It was put up to not get lost.

Who is online

Users browsing this forum: No registered users and 1 guest