My very, very DIY tripower intake mod.

Dunno for sure.

I'd bet on the repurposed Vac gauge. Fuel pressure gauge or a bleed back line is my guess.

It might be one of these.

All I know is he has a Vac gauge on top,

RPM at center, flanked by volts and the three others, I can't tell. Knowing FSD, he'll use all the visual tell tales and the obscured wheel won't remove any thing he needs to know. It may be from Beaver Springs, but their isn't any BS in this 65 Must Fang




As Mr Ford said as Hans

Well I'll give everyone an update on Faron's six. I wish I could tell everyone that it's in the car and running but I had big problems with th 64 Falcon and it has been replaced with a 65 Futura. I have just finished all the suspension parts swap over and I am finally getting ready the start the engine install. That's going to take some time because the new car is a automatic and I'm doing the T5 swap. With a bit of luck I might make it before I have to have shoulder surgery which won't help with the swap (always something).
I will let you all know when it's in.
It will live again!

Gene