So I'm new to this site, so I apologize for any mistakes I make, but I have a ford 200 online six (in my 1965 mustang with a 3 speed) and it was missing and running rough so I decided I'd rebuild it. I've taken so much time measuring clearances all the way to cleaning and prepping the block. Long story short I've replaced EVERYTHING besides the rods(checked and all by machine shop, block (bored .30 over and checked), and the head (valve job and checked for cracks). I still have a very rough idle and like its missing but all the wires are showing no evidence of a miss (I've tested for it) and I'm not sure what to do because I've dumped a lot of money into rebuilding this engine with no luck, just for it to run the same way as it did before I rebuilt it
Any info/help would be greatly appreciated
Any info/help would be greatly appreciated