Two questions that arose while calculating and measuring for static compression on my 200:
All my pistons have „30“ stamped in their dish, does that mean that my block is bored .030 over?
And I measured my piston to deck height with a deck bridge and a dial gauge. I measured between 0.87mm and 0.92mm, which equals to a piston to deck height of .034“ to .036“. I found this thread where also .031 is mentioned: Negative Deck Height for 200 | FordSix Performance Forum
Has anyone else a similar deck height?
All my pistons have „30“ stamped in their dish, does that mean that my block is bored .030 over?
And I measured my piston to deck height with a deck bridge and a dial gauge. I measured between 0.87mm and 0.92mm, which equals to a piston to deck height of .034“ to .036“. I found this thread where also .031 is mentioned: Negative Deck Height for 200 | FordSix Performance Forum
Has anyone else a similar deck height?