200 crank installation

[Anonymous]

What is the proper sequence and torque specs for the crank and rod bearings on a 77 200 ?

 

[james singleton]

Jim in Georgia, This may not help, but it is the best I can do. In the manual that I have which only has "Torque Specifications" for a 1965 - 200cid engine it lists 19-24 ft.lbs for Rod Bearing Bolts, and 85-100ft.lbs for Crankshaft Pulley Bolts, and 75-85ft.lbs for the Flywheel-to-Crankshaft bolts. Jim in Ca.

 

[Anonymous]

Jim,
I also found some information on the Classic Inlines site. Shows mains as a three step process: 1) 40-45 2) 55-60 and 3) 65-70. Rod caps 24-26. The had is also a three step torque sequence.
I knew that I had seen it somewhere before starting the overhaul. Now I'm ready to put it back together.
Thanks for the help,