Its a F350 with a 460 big block and C6 trans.
As you can see, most things have been modified.....
Couldn't find any photos of the inside of the van, but its well equip.
Well, it's been a while since I last posted
Electrics done, engine built and going in. Should only be a week or so before we have noise
Then out for its first run in the January meeting.
Few of the head...
Managed to get 0.080" off the head + using the AU head gasket (0.025" against 0.050") + a light clean up of the block, 0.010"
CR will be in the mid 11:1's. Will be running BP98 pump fuel.
Bit of port work, nothing to fancy.
Biggest limitation was the inlet valve relief. The first cam supplied had the cam details listed as at the valve, but was actually at the cam lobe. Made it much larger than we wanted.
Had to have it reground to the right specs.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.