66 Mustang Conv/L6/Sprint 200/Auto- need these parts

[bandit66]

Please see the pics below. I haven't had any luck finding these parts.

*Pics 762,763 show the fitting (male 1/4", female 3/8") that connects the transmission vacuum line (pic 564) to the intake manifold (pic 589).
http://members.cox.net/steel3rivers/IMAG0564.jpg
http://members.cox.net/steel3rivers/IMAG0589.jpg
http://members.cox.net/steel3rivers/IMAG0762.jpg
http://members.cox.net/steel3rivers/IMAG0763.jpg

*Pics 755,559 show a short fitting (connects one heater hose to the intake manifold). http://members.cox.net/steel3rivers/IMAG0559.jpg
http://members.cox.net/steel3rivers/IMAG0755.jpg

*Pics 755,554 show a long fitting (connects one heater hose to the water pump).
http://members.cox.net/steel3rivers/IMAG0554.jpg
http://members.cox.net/steel3rivers/IMAG0755.jpg

Thank you.

 

[Explorer]

Any good parts store should have those. Try NAPA and take the old ones with you. You'll never find them looking up on a computer for specific vehicles. They are plain old NPT fittings.

 

[MPGmustang]

Welcome to the Forum!!! yes it's that good! 8) arty:




for the hard vacuum line hose to the tranny, try a brake 5/8 brake line, you can change it for a smaller hose as it dosen't need to be that big... availible at any autozone or checker/oriely's

90* angle brass inverted fitting try Ace hardware, I know they have them here in AZ...

the heatter hose pipe should also be found at Ace Hardware

I recomend bringing your parts with you for visual comparison,

 

[bandit66]

Ok. Thank you.

 

[MrMootsie]

I just re-plumbed my power front discs and transmission vacuum lines to the manifold, and I used brass plumbing fittings from Ace. I believe it's a 1/4" plumbing thread.