DIY meth/water injection

kirkallen143

Famous Member
Well, I am going this route instead of race gas/e85 (Hard finding e85 in my area and don't want to pay for $12.00 a gal. fuel). Plan on using a 50/50 mix, is denatured alcohol and distilled water good for that, or just windshield washer fluid?

Just picked up a pump today, 2.1 GPM @ open flow and 60psi, and this should be big enough for 10-15psi of boost (got them at w.w. grainger or northerntool). Still need to get a relay, fuse, switch, water soleniod, pressure switch, nozzles, etc...

There is a good write up here for the do it yourselfer:
(Tommy are you reading this?)

www.turbomirage.com/water

I will let y'all know how it goes.

Kirk
ps. time for some steam cleaning
 
I know, I know, and I was going that route but always got outbid on ebay for any real clean propane setups. So I just stuck with the good ole carb set up, and to my surprise is doing very, very well (rocks, sand drags, etc...)
Actually, I just needed to fill up some space in my engine bay, reason #1 for the meth/water injection :lol: .

Kirk
 
kirkallen143":y18qko3n said:
There is a good write up here for the do it yourselfer:
(Tommy are you reading this?)

Its already in my bookmarks :D , I have looked into it but decided I Would get my car running decent before hand but by the time I had it good the tranny went out... I have to get time to pull it and send the numbers to miek to see about having one made, and do my first tranny rebuild. I personally like the front mount and can say I am 100% sure that it helps. after beating er ummm driving it you cant hold the piping before the intercooler, after it is the same temp as outside. with the old setup w/o the intercooler the carb hat would get pretty hot!
 
Back
Top