got the cam

[Anonymous]

I finaly got my cam and its @50" 194 int 204 exh lobe spread 110 valve lift .464 int 491 .exh cam lift .265 int .281 exh I`m gona put it in when I rebild it and its going in with a 79-82 head rbs carter (215 cfm) and a K&N air filter I`m also going to port the head so how much hp that sound like thanks

 

[Anonymous]

oh ya is clevite performance a good brand ???

 

[CoupeBoy]

I think any engine I ever rebuilt had clevite bearings, I have never heard anything bad, so I say yes, they are quite excellent..

-ron

 

[addo]

My port experience is ongoing... :roll: I'm not done, and have so far acquired the following bits for use (all solid carbide burrs) 5/8 "Xmas Tree", 5/8" ball, 1/2" ball, 1/2" ball-end cylinder. Want to get a 3/8" ball-end cylinder, too. In US money, there's about $190 for that bunch. So the results better be good!

My point? Shooting for the ideal results can require quite a lot of spending on gear to get you there. But it's noisy, messy and fun to port heads.

Regards, Adam.