Tell me if this sounds right.
Intake valve diameter is 1.84"
Assuming intake flows 170cfm (I know I'm being optimistic)
Optimally I need a intake runner inside diameter of 1.65 with top at plenum being 1.75in in diamater
Plenum should be about 4 in diamater and about 18in to 20in long with rear angled down giving a internal volume of about 225 to 250 cubic inches.
I have a Ford 65mm throttle body and I will be running 65lb/hr injectors (Larger than needed to account for E85 fuel).
Anyone see anything that needs changed? Comments appreciated.
Thanks!
Mark
Intake valve diameter is 1.84"
Assuming intake flows 170cfm (I know I'm being optimistic)
Optimally I need a intake runner inside diameter of 1.65 with top at plenum being 1.75in in diamater
Plenum should be about 4 in diamater and about 18in to 20in long with rear angled down giving a internal volume of about 225 to 250 cubic inches.
I have a Ford 65mm throttle body and I will be running 65lb/hr injectors (Larger than needed to account for E85 fuel).
Anyone see anything that needs changed? Comments appreciated.
Thanks!
Mark