I was feeling ambitous. I wanted to shake a demon off my back and succesfully rebuild and properly tune my carb. So far so good. Until now. Now being the vent rod adjustment. The instructions say to bend the actuating lever to adjust the vent rod. Problem is the lever in the drawing and the lever on my carb look a little different.
I took some pictures with my cell in the hopes of posting the pics here, but I can't seem to open them past preview in my email. Is there anyone willing I can send these to and have them get it open and post here? Thanks.
I took some pictures with my cell in the hopes of posting the pics here, but I can't seem to open them past preview in my email. Is there anyone willing I can send these to and have them get it open and post here? Thanks.