question about flexplate / starter for 69 mustang 250cid

[grendi_250ci]

as mentioned in the thread title, i need a new flexplate and a new starter for my mustang.
my current flexplate has 157-teeth and the converter bolt pattern is 10.5"
http://mitglied.multimania.de/donquest/L-Code/flexplate1.jpg
http://mitglied.multimania.de/donquest/L-Code/flexplate2.jpg
http://mitglied.multimania.de/donquest/L-Code/starter1.jpg
http://mitglied.multimania.de/donquest/L-Code/starter2.jpg
http://mitglied.multimania.de/donquest/L-Code/starter3.jpg

do you think these parts here will fit?
http://www.summitracing.com/parts/BMM-50246/
http://www.summitracing.com/parts/TFF-3124B/ or http://www.summitracing.com/parts/PWM-3124/ (the picture is probably wrong)

 

[bubba22349]

Yeah should work is a zero balance. Starter two if it's the right offset.

 

[powerband]

Flex plates should be same as SBF as in llink. ( note it is not SFI rated if you are racing :roll: ), 250 can use any later model SBF starter and a modern 80's/90's "mini" starter (PMGR permanent magnet gear reduction) will spin easier and be lighter and smaller for same price. As noted early (60/70's?) SBF used a seperate starter for standard bellhouse/157T FW . Later were all same as" early" automatic (C4) 157T BH - nose projection is @ 3/8 or 3/4" .

have fu


PMGR starter:
http://www.summitracing.com/parts/SUM-829302/


250 157T/FP/starter:

>?

250 with PMGR starter:
<>

 

[woodbutcher]

The starter pictured is for a chebby.
Good luck.Have fun.Be safe.
Leo