Hi there, I need a distributor drive gear for a fuel injection and electronic ignition conversion that includes removing the distributor and replacing it with an oil pump drive from a late model engine. I'm looking for a distributor drive gear for that setup that will work with my Clay Smith camshaft. Have been trying to contact CI but haven't heard back so I'm looking for another source. Any recommendations?
source for distributor drive gear?
- Thread starter falcon fanatic
- Start date
Does it need cam sync.
drag-200stang":27uhdg2c said:
No, I'm using a magnetic crank trigger timing wheel. I just need a way to drive the oil pump off of the camshaft so I don't have a big, bulky distributor (i have a DUI - They're huge) sticking in the middle of my engine bay doing nothing.
What happened to Mike? 
Oh, that's sad news. Thanks for the update.
I really need a rocker arm assembly for my 67 Mustang; tried to order from Classic Inlines with no luck. I have a 200 straight 6, need non-adjustable 1.5 stock rocker ratio. Any suggestions where I can get the whole assembly? Also need push rods.
candy1hot67, You could try posting an add in the Wanted section and also look in the Small Six parts For Sale Section these are located at the bottom of the Forum sections. Site member "amartin83" listed a non adjustable rocker set for sale (for 20.00 + shipping). It was a while back that you could check on if they are still available, for info see the link below. Good luck 
viewtopic.php?f=86&t=73052
viewtopic.php?f=86&t=73052
A little pricey, but if you're in a pinch, I found this.
http://www.ebay.com/itm/60-1961-1962-19 ... 24&vxp=mtr
I bought my rockers (16 of 'em) and rail for about half that. Most of my parts were still in the OEM packaging
http://www.ebay.com/itm/60-1961-1962-19 ... 24&vxp=mtr
I bought my rockers (16 of 'em) and rail for about half that. Most of my parts were still in the OEM packaging
