Click Here -> Please Consider Making a PayPal Contribution to the FordSix Forum!
2018 Contributors:
StarDiero75, curts56, DannyG, B RON CO, wsa111, Captainslow42, falconcritter
Econoline, THE FRENCHTOWN FLYER, 95FordFleetside, turbo6, Max_Effort, WorldChampGramp
cr_bobcat, C.S.Designs, pmuller9, gus91326, rwbrooks50, rocklord, drag-200stang, Big64my79Effie, CNC-Dude, gb500

2019 Contributors:
NJwpod, 1strodeo, mightynorseman, maxtrux, 6d7coupe, broncr, Phase3, 68Flareside240

Unknown->> S.Wickett, D.Blaine - Please PM me (1966Mustang) and lemme know who you are!

Gasket Sheet Material

Moderator: Mod Squad

User avatar
Assistant Admin
Posts: 586
Joined: Mon Nov 18, 2002 3:07 pm
Location: San Francisco

Gasket Sheet Material

Post #1 by 65coupei6 » Wed May 16, 2018 9:15 pm

Any recommendations for a gasket sheet. This will be used on the aluminum head between the intake and carb. adapter plate.

I was thinking:
FelPro #3046
Or #3195

I think they are both the same. Just different colors.

'65 Mustang Inline 200. VI (CI) Aluminum Head, Holley 350, Schneider 264/274 cam,
Headers, DSII, MSD 6A, and a whole lotta other stuff!

Build That Six With Parts From

User avatar
Global Moderator
Posts: 8736
Joined: Sun Jan 03, 2010 4:46 pm
Location: Flagstaff, Az. 86005 near the old Route 66

Re: Gasket Sheet Material

Post #2 by bubba22349 » Thu May 17, 2018 1:01 am

They are probally going to work ok it says on the first one that it's 1/32 thick that's maybe a little bit thin for a carb base gasket in my OPIN. Good luck :thumbup: :nod:
A bad day Drag Racing is still better than a good day at work!

I am still hunting for a project car to build but with my current low budget it's not looking so good. My Ex- Fleet of Sixes these are all long gone! :bang: 1954 Customline 223 3 speed with O/D, 1963 Fairlane project drag car with BB6, 1977 Maverick 250 with C4, 1994 F-150 a 300 with 5 speed.

Registered User
Posts: 1007
Joined: Sun Oct 19, 2003 6:10 pm
Location: Michigan

Re: Gasket Sheet Material

Post #3 by drag-200stang » Thu May 17, 2018 8:52 am

I agree with bubba , it is a little thin...If it is very flat it is a good thing..It will not distort the mounting points as much, but when is this stuff ever flat...I like permatex #2.
66 Mustang Coupe
200 turbo w/lenco 4-spd
stock adj. rockers, stock timing set, ARP studs
best 1/4 mile ET 9.85/best mph 139 on 8 lbs progressing to 15 lbs boost
Went 9's when 10's was fast.

Who is online

Users browsing this forum: No registered users and 17 guests