Hey everyone, finally getting around to finishing up my engine and when I went to adjust my rockers i noticed there was barely any
clearance between the push rod and bore of the cylinder head. looked at a couple others and they were even contacting. I've got an 200 with the aluminum head and the 1.6 factory style adjustable rockers. It seems as if the rocker itself is not long enough to keep the push centered in the bore or the bore was not machined big enough. I took the rocker assembly back off to inspect and didn't take any pictures but there are marks on some of the push rods from touching.
Anyone run into this problem before?
clearance between the push rod and bore of the cylinder head. looked at a couple others and they were even contacting. I've got an 200 with the aluminum head and the 1.6 factory style adjustable rockers. It seems as if the rocker itself is not long enough to keep the push centered in the bore or the bore was not machined big enough. I took the rocker assembly back off to inspect and didn't take any pictures but there are marks on some of the push rods from touching.
Anyone run into this problem before?