Click Here -> Please Consider Making a PayPal Contribution to the FordSix Forum!
2019 Contributors:
NJwpod, 1strodeo, mightynorseman, maxtrux, 6d7coupe, broncr, Phase3, 68Flareside240, bmbm40, mustang6, WorldChampGramp, justintendo, BigBlue94, ags290, motorsickle1130, Rooster, ousooner919, ethanperry, rzcrisis, DoctorC, jamyers, Motorboy, fastpat, Silverback280, chad, drag-200stang, THE FRENCHTOWN FLYER, Jimmys61falcon, rjonah, Sooshi, Robert92867, Invectivus


<<<***PLEASE READ*** New Site Update >>>

Finished porting job

Moderator: Mod Squad


Finished porting job

Post #1 by Guest » Tue Mar 25, 2003 1:05 am

Since the cylinder head was off, I had to do it.

Finally! A porting job I started 4 years ago and never finished. Feels pretty good finally having accomplished it!

Ctown :checks:

User avatar
VIP Member
Posts: 7070
Joined: Sat Nov 09, 2002 10:40 am
Location: PO Box 7072 Dunedin 9011,South Island, NEW ZEALAND

Post #2 by xctasy » Tue Mar 25, 2003 7:16 am

That's a great bit of kit, Ch**y! Just like a Holden head, only bigger in every direction!

Even better to see you haven't polished the insides, like a lot of misgiven head hoggers do.
XEC Ltd ICBE's Inter Continental Ballistic Engines-
FAZER 6Bi (M112 & EEC5) or FAZER 6Ti (GT3582 & EEC5) 425 HP 4.1L/250 I-6
FAZER 6V0 3x2-BBL Holley 188 HP 3.3L/200 I-6 or 235 HP 4.1L/250 I-6
X-Flow Engine Components Ltd


Post #3 by Guest » Tue Mar 25, 2003 10:51 am

Sup fella!

I didn't go all the way. There are some small patches on the exhaust ports I didn't clean up only because if I did, I would have to remove more material to make it uniform which I didn't want to do.

I also received the new chip for the ECM/TBI. They leaned it out in the lower RPM's. Can't wait to try it out.


User avatar
VIP Member
Posts: 479
Joined: Thu Dec 19, 2002 9:30 pm
Location: Columbus, Ohio

Post #4 by DaGr8Tim » Wed Mar 26, 2003 1:40 am

Looks great, I can't wait to jump into my Ford I4 head.
A)bort, R)etry, I)nfluence with large hammer

1997 Jeep Cherokee
1975 Jeep CJ5 with a hacked CJ7 tub

Who is online

Users browsing this forum: No registered users and 2 guests