Hey guys,
I am not very keen on turboing an engine at all, but I have been thinking about adding one to my exitsting engine or building another engine specifically for turboing.
The current engine is:
250 .030 over
Forged pistons
CS 280 *110 HYD cam
CI aluminum head slight port and polish
1.6 adjustable rockers
10.25 CR
With that set up could I possibly run a turbo at 5lbs and be ok?
If so, will the felpro head gasket survive? Or do I need to find a thinner one? What size turbo should I go with for low boost, but spools up quicker for daily driving use?
If turboing is out of the question on that engine, how would you guys suggest building a 250 for turboing? What size turbo should I go with?
Thanks guys!
I am not very keen on turboing an engine at all, but I have been thinking about adding one to my exitsting engine or building another engine specifically for turboing.
The current engine is:
250 .030 over
Forged pistons
CS 280 *110 HYD cam
CI aluminum head slight port and polish
1.6 adjustable rockers
10.25 CR
With that set up could I possibly run a turbo at 5lbs and be ok?
If so, will the felpro head gasket survive? Or do I need to find a thinner one? What size turbo should I go with for low boost, but spools up quicker for daily driving use?
If turboing is out of the question on that engine, how would you guys suggest building a 250 for turboing? What size turbo should I go with?
Thanks guys!