Rebuild your 2.77 Transmission

Status
Not open for further replies.
Hey there Mustang 6 thanks for posting this link ;)

Tell your HAMB buddy that the onger tail shaft tranny is a mustang tranny... I have a 2.77 and a 2.7 out of a floor shift mustang and a 303 out of another application and each one is larger than the last by about the same increments... I was going to just pop in the Mustang 2.77 but the tail shaft was longer like the one you show, and the main body was about 10 lbs heavier and 1 inch longer, My 2.77 weighs in at about 30# and the 303 is about 75 to 80#, the Mustang 2.77 (or whatever it's designated) is about #40...

Just some info I thought might be usefull for some silly reason...

I need a clutch, catch ya'll later :)
 
Status
Not open for further replies.
Back
Top