falcon_master
Well-known member
Hi everyone. So I just "rebuilt" my carburetor. I say it in marks because i honestly barely knew what I was doing and alot of it was well this is how it came off. So it's most likely that that is causing it to run like crap but I wanted to make sure with you all. So it'll idle great I mean really low like 500 RPM no problem but as soon as you even breathe on the throttle it'll die. I fixed it by manually pushing the squirter to squirt gas in the carb and pushing the throttle at the same time but even when it idled up it started to run so bad I was concerned the while car started shaking viontley and you could see the engine shaking. It was like when you are starting out from a stop on a manual and it starts to stutter and shake. But this was at high RPM. Any ideas on what to adjust I don't know how to adjust the AF ratio on this guy. Another problem I'm fighting is the trans. It's making a horrible noise out of the bell housing/input shaft area. Its like a really bad clunking. If you put in gear and let out the wheels will move. But it isn't good it gets louder with increased RPM. It seems to go away when you step on the clutch but I still hear something. How hard is to change a input shaft bearing on these guys and where do I find them?