250 oil pump shaft bushing part number

isn't there a bushing that presses into the engine block to support / guide the oil pump drive shaft from dist to oil pump ? I haven't disassembled my engine yet but this is what I was led to believe.
 
I assembled my 250 recently ... No oil pump drive shaft bushing. The shaft, which is shorter than the shaft on a 200, fits into the oil pump and the dist. shaft.

Thanks
Bob
 
This a caution to all .

There is a few drive shaft length combos. Make sure that it is not to short or to long. I had one that was about .012'' to long just enough not to be noticeable, distributor tightened down ok. On later freshen up found the damaged pump . :bang:
 
got any measurments by yr?
 
Bob, you are welcome .

It took me a long time to learn about these engines.....one mistake at a time ...some times two. :oops:
 
Comparing shaft lengths is a good idea. It might also be a good idea to compare the hole depths on the pump and the dizzy since they are both after market pieces.

Keep up the good work.
 
falcons99":3rysdirq said:
Comparing shaft lengths is a good idea. It might also be a good idea to compare the hole depths on the pump and the dizzy since they are both after market pieces.

Keep up the good work.
Click to expand...

:thumbup:
 
You must log in or register to reply here.

Similar threads

F
All Small Six Block identification help.
Replies
3
Views
366
John Ha
John Ha
E
Oil pump for a 64 bolt into a 62 223 block?
Replies
6
Views
515
Frank
Frank
Q
All Small Six Engine fasteners
Replies
4
Views
375
philford
philford
TrickSix
All Small Six Rocker Shaft Supplemental Oil Supply?
Replies
2
Views
1K
TrickSix
TrickSix
Invectivus
All Small Six rocker rebuild
Replies
4
Views
892
frozenrabbit
F
Back
Top