Anotha DIY el cheapo EFI project

[80Stang]

This is what I figured out that might have a future:

- got a box full of early '80s ('83-'84) CFI stuff from a 302 bent-8. Two TBIs, all the wiring and sensors from one engine.
- have a rebuild kit for a TBI; will be done soon
- have a gas tank off a 92GT, with a fuel pump in tank. I have learned that the stock pump should be good enough for the CFI
- ordered a Megasquirt I kit with the new 3.0 board, and the stim
- got a laptop...
- lambda is already there

Maybe someday it works. Suggestions?

 

[Anonymous]

I have the complete 1984 3.8 liter V-6 CFI set-up I need to get rid of. It would be easier to adapt a V-6 TFI distributor than a V-8 one.

 

[80Stang]

At this stage I thought of controlling only fuel, and if/when I go to MS II to take good control over ignition then I'll dive into crank triggers and coil-packs and retire the dizzy.

I'm on the early phases of learning curve, all help is appreciated. Thanks.