All Small Six Camshafts

[pmuller9]

 

[pmuller9]

 

[pmuller9]

Reserved

 

[DON]

Thinking about getting one for down the road- if they become hard to get. Then again there might be a roller for the small six too!!

 

[pmuller9]

Thinking about getting one for down the road- if they become hard to get. Then again there might be a roller for the small six too!!

cr_bobcat is working on the possibility of fitting the Morel 300 six roller lifters into the 250 six and possibly the 200 six.
If so, then roller cams will be possible

 

[DON]

I would think ( and hope ) SOMEONE would still manufacture hyd cams in the future

 

[aussie7mains]

I would think ( and hope ) SOMEONE would still manufacture hyd cams in the future

CROW.

 

[cr_bobcat]

cr_bobcat is working on the possibility of fitting the Morel 300 six roller lifters into the 250 six and possibly the 200 six.
If so, then roller cams will be possible

Yup. Just waiting on them to arrive. There was a snafu in shipping. They just went out today. Should have them in a couple days.

Clay Smith has been a good go to for a number of years. I really like the 264/274 110° that I have. It's the older grind with slightly more lift than what is on the new card.

 

[aussie7mains]

cr_bobcat is working on the possibility of fitting the Morel 300 six roller lifters into the 250 six and possibly the 200 six.
If so, then roller cams will be possible

IMO unless you really improve the breathing a LOT on the USA sixes, a roller is a waste of effort, given the head wont allow NA power above about 6000rpm, why would you need rollers?

 

[pmuller9]

IMO unless you really improve the breathing a LOT on the USA sixes, a roller is a waste of effort, given the head wont allow NA power above about 6000rpm, why would you need rollers?

Because the USA flat tappet cams have a high rate of lobe failures and since there are no longer any new flat tappet cam cores available, once the present shelf supply is gone then there will be NO USA flat tappet cams.
The 300 six is at that crossroads and is why we made an effort to make 240/300 roller cams available.