found a better carb hat sealing ring

[gravelrash]

hey guys i have researched and developed a rubber seal to seal the carb bonnet.
made of thick rubber, its fuel, oil, and heat resistant.

i have tested it up to 24psi with no problems at all.
not a problem sending to the USA.



http://cgi.ebay.com.au/ws/eBayISAPI.dll ... :MESELX:IT

 

[351 celi]

Any chance you plan to develope one for 2v autolites. Great looking part though, very much needed! Good job.

 

[FalconSedanDelivery]

They take the Same seal

 

[351 celi]

It doesnot look like it would work based on how it mounts in the photo, though the diameter is the same.

 

[gravelrash]

if a holley gasket fits on a Autolite, then this will fit the Autolite.

cheers Greg

 

[351 celi]

It looked as though the gasket you developed encompasses a complete 360 degree lip in the photo, a continuous lip is not found on the autolites, but the ID is the same as a holley. If it simply rests upon the top of the carb like OEM but better material, that is great and you all are right, it will work. I just bought two new felpro gaskets because of this very problem, so looks like you'll have another order. Thanks again.