So I really want to do the Tempo EFI conversion. My problem is my mom heard the cost and she wants me to work on paying her and my dad back first. I can buy anything I want for the car provided it's not over $200.
So my plan is to prep the rest of the car for the EFI first in the hopes of a lot of smaller costs are taken care of and I could at least try to use the line "but everything else is already there"
Somethings I need to know however are:
1) Can I get an electric fuel pump that will be able to handle the EFI when I finally switch over BUT at the same time be able to regulate the flow down enough so I can use it with the stock carb?
2) I've been told to replace the linkage system with a cable type setup. Again, would it be possible to buy a throttle cable to work with the carb then later be modified for the TB.
3) Can I install a bung in the exhaust system for the o2 sensor and put a plug in until I'm ready for the rest of the swap? Also, should the bung be in the manifold or in the pipe directly after the manifold?
4) Same goes for the return line. Can I simply install a bung on the tank for the return line but block it off until I'm ready?
Anything I'm missing? Thanks.
So my plan is to prep the rest of the car for the EFI first in the hopes of a lot of smaller costs are taken care of and I could at least try to use the line "but everything else is already there"
Somethings I need to know however are:
1) Can I get an electric fuel pump that will be able to handle the EFI when I finally switch over BUT at the same time be able to regulate the flow down enough so I can use it with the stock carb?
2) I've been told to replace the linkage system with a cable type setup. Again, would it be possible to buy a throttle cable to work with the carb then later be modified for the TB.
3) Can I install a bung in the exhaust system for the o2 sensor and put a plug in until I'm ready for the rest of the swap? Also, should the bung be in the manifold or in the pipe directly after the manifold?
4) Same goes for the return line. Can I simply install a bung on the tank for the return line but block it off until I'm ready?
Anything I'm missing? Thanks.