Is a stroker possible

[Anonymous]

Will a 300 crank go in a 250. probably sounds like a dumb question. If its possible to use 200 rods in a 250 with ACL lower pistons then maybe its possible to use 250 rods and the lower piston on a 300 crank in a 250.
Im probably dreaming but I thought I would throw it out there anyway.

 

[Anonymous]

Just realised dumb question it wont fit and you would need a crank with an even longer stroke and the same length rod would give an even worse ratio with a longer stroke (what was I thinking).
Please delete this off forum unless someone comes up with some rocket science from Mars.
Cheers all !

 

[Anonymous]

tim please refer to another thread i started in this catagory titeled
"300 cu in crank spacings"
you may get some ideas there.

cheers.joe.