I'm almost done building the plenum box for my setup.
I have two Weber 36-36 carbs off 1985-ish Masterati Biturbos on ...
... a Clifford dual-quad intake with...
...home-made adaptors.
The plenum box ended up being about 1100 cubic inches to fit both carbs inside. Corky Bell recommends that the plenum be about 110%-120% of engine volume, meaning that my plenum is much larger than it should be.
Does anyone have any experience / recommendations on this subject?
I'm thinking that once I'm done, I'll find some pieces of foam or wood to put inside the plenum box to reduce its volume. What do you think?
I have two Weber 36-36 carbs off 1985-ish Masterati Biturbos on ...
... a Clifford dual-quad intake with...
...home-made adaptors.
The plenum box ended up being about 1100 cubic inches to fit both carbs inside. Corky Bell recommends that the plenum be about 110%-120% of engine volume, meaning that my plenum is much larger than it should be.
Does anyone have any experience / recommendations on this subject?
I'm thinking that once I'm done, I'll find some pieces of foam or wood to put inside the plenum box to reduce its volume. What do you think?