I have noticed that the gasket around the main body of my carbs are showing signs of leakage. I have always been under the impression that this means the fuel level in the bowl is too high. I have the 34's with choke circuit and set them per Pierce Manifolds specs< but I think this may be too high-what have you guys set them at for best results?
Weber 34 float level?
- Thread starter JOHN G
- Start date
Junk-Falcon
Well-known member
ppp
Junk-Falcon
Well-known member
ppp
Yes to the regulator-I had talked to Pierce and they had me set them to 8mm,but I'm seeing the signs of leakage. I went into my tech specs for the carbs and they say 6.5mm. I do tend to drive the car a little hard(why have 3 carbs otherwise?!) so will this setting empty out the bowls to soon? I'm thinking 8mm on the primary and 6.5 on the outers?
