I used to use the table in the tech section but it doesnt seem to be there anymore, maybe it never was and I used a different table?
My Haynes manual lists almost every spec but does not list the compression height.
What I am asking about is the distance from centerline of the piston pin to the top surface of the piston for a 200 I6. In my paticular case its a 1980-81 motor.
My Haynes manual lists almost every spec but does not list the compression height.
What I am asking about is the distance from centerline of the piston pin to the top surface of the piston for a 200 I6. In my paticular case its a 1980-81 motor.