On a 3/8 24 (US Fine thread) that Ford used, these studs that were a grade 5 torque was 24 to 27 FT LB's. If you used a corse thread or a grade 8 than the torque will be different. Ie a grade 5 corse thread stud would be a max of 23 ft lb. I don't have access to the bolt torque pattern but if you start at the center and work out you should be close enough. I have made it my practice to always torque bolts in steps i.e. Such as head, main bolts in three steps, and intake exhaust ect in two steps. Intake and exhaust bolts I will retorque after the engine has run a while. Good luck
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.